BMW K 1200 GT Getriebeöl-Wechseln: Anleitung & Tipps
Ready to maintain your BMW K 1200 GT's performance and longevity? One critical aspect of routine care is getriebeöl wechseln—changing the transmission oil. This procedure is essential for preserving your motorcycle's smooth shifting and overall power transfer. In this comprehensive guide, we'll walk you through the process, ensuring you have everything you need to complete the task confidently and efficiently.
The first step in changing your BMW K 1200 GT's transmission oil is gathering the necessary tools and materials. You'll need the following: a 10mm Allen wrench, a 17mm socket and ratchet, an oil filter, 1.9L of BMW's specified SAE 75W-90 GL-4 transmission oil, and a large drainage container. With everything at hand, let's dive into the step-by-step process.
Preparation
Before starting, ensure your K 1200 GT is on a level surface and has cooled down for at least 30 minutes to prevent any injuries from hot components.
Next, locate the transmission oil drain plug at the bottom of the gearbox, towards the left side. It's hidden beneath the engine bell housing, so you might need to remove the fairing orMichelin Road 2 tires' splash guard for better access.
Draining the Old Oil
Using your 10mm Allen wrench, loosen and remove the drain plug slowly by turning it counterclockwise. Place your drainage container underneath to collect the oil.
Allow the oil to drain completely, which may take up to 30 minutes. Once finished, wipe the area clean to prevent contamination and locate the oil filter on the right side of the gearbox, closer to the rear wheel.
Replacing the Oil Filter
Before removing the oil filter, use some new transmission oil to lightly lubricate the gasket. This will ensure a proper seal and easier removal.
Now, use your 17mm socket and ratchet to loosen and remove the oil filter. Once off, discard it and lubricate the new oil filter's gasket with fresh oil. Install the new filter by hand, ensuring it's snug but not overtightened.
Refilling the Transmission
After replacing the oil filter, it's time to refill the transmission with new oil. Locate the oil fill hole on the left side of the gearbox, near the top. It's closed by a plastic cap, which you can remove.
Slowly pour the recommended 1.9L of new BMW SAE 75W-90 GL-4 transmission oil into the gearbox, checking the oil level periodically to avoid overfilling. The ideal oil level is when the oil is at the bottom of the fill hole when the vehicle is level.
Reinstalling the Drain Plug
Once the correct oil level is reached, replace and tighten the drain plug securely, using your 10mm Allen wrench. Tighten it to the specified torque of 25 Nm (18 ft-lb).
To ensure proper operation and accurate oil level readings, run the engine at high RPM for approximately 30 seconds to allow the new oil to circulate and reach the oil-level inspection hole. After shutting off the engine, wait a few minutes for the oil to settle before rechecking the oil level.
Final Checks
Use a clean, lint-free cloth to wipe the area around the oil fill hole clean, then recheck the oil level. If necessary, add small amounts of oil until the level reaches the bottom of the fill hole when the engine is cold and the motorcycle is on a level surface.
Once the correct oil level is achieved, replace the oil fill cap, reattach the fairing and splash guard (if removed), and dispose of the used oil and filter responsibly.
Congratulations, you've successfully completed the transmission oil change on your BMW K 1200 GT! Regularly performing this maintenance task will keep your motorcycle shifting smoothly and operating at peak performance. Enjoy your rides, and don't forget to check the oil level every 500 miles to maintain optimal performance.