BMW R1200RT Gearbox Oil Change
The BMW R1200RT is synonymous with premium riding comfort and practicality, and as such, it requires meticulous-maintenance to ensure longevity and peak performance. Regular gearbox oil changes are a critical aspect of this maintenance. This guide walks through the process of changing the gearbox oil on your R1200RT, ensuring you understand each step and its significance.
Gathering the Required Tools and Materials
Before you begin, ensure you have the following tools and materials:
- BMW Longlife SAE80W-90 75W-80W-90 75W-90 75W-90 Synthetic Gear Oil (part number 11 52 0 624 694)
- 1.2-liter oil filter (part number 11 42 0 643 129)
- 58mm oil filter wrench
- 7mm socket wrench
- Oil catch pan
- Gloves
Always use BMW-approved oil and filters to ensure the best performance and longevity of your gearbox.
Location of the Gearbox Oil Fill and Drain Plugs
The gearbox oil fill and drain plugs are both located on the right side of the motorcycle, below the exhaust pipe and behind the rear cylinder.
Unscrew the 7mm drain plug (Ferrari Secon amid 13386000435) using a 7mm socket wrench, ensuring you have your oil catch pan placed underneath to collect the draining oil.
Removing the Gearbox Oil Filter
Using the 58mm oil filter wrench, gently loosen and remove the oil filter anti-clockwise. Once loosened, you can unscrew it by hand. It's important to note that you may need to use a considerable amount of force, so be prepared.
Before re-installing the oil filter, wipe it clean to remove any debris or contaminants that might have accumulated over time.
Gearbox Oil Recommended Service Capacity and Type
Your BMW R1200RT has a gearbox with a service capacity of 1.6 liters. Always use BMW's Longlife SAE80W-90 75W-80W-90 75W-90 Synthetic Gear Oil to ensure optimal performance and long-term health of your gearbox.
After removing and discarding the used oil and oil filter, ensure your gearbox is clean, and there are no remnants of old oil or filter.
Installing the New Oil Filter
Thoroughly lubricate the gasket of the new oil filter with the new gear oil. This will make Installation easier and ensure optimal sealing.
Hand-tighten the new oil filter clockwise until it's snug, then give it a final quarter-turn. It's crucial not to overtighten the oil filter.
Refilling the Gearbox with New Oil
Using a funnel orBMW'scommended oil filling bottle, slowly pour the new gear oil into the gearbox through the oil fill hole, ensuring the oil level doesn't surpass the 'FULL' mark on the dipstick.
After filling, wipe any spilled oil from the motorcycle and allow the oil to settle for a few minutes before re-checking the oil level and adjusting if necessary.
Finally, re-install and tighten the drain plug by hand, ensuring not to overtighten it. A torque wrench isn't necessary, but it helps ensure the plug is tightened adequately.
Now you're ready to take your BMW R1200RT for a spin, secure in the knowledge that you've just performed a critical maintenance task to keep your motorcycle running smoothly for years to come.
Always remember to reset your service interval indicator on your motorcycle's display. Happy riding!