"The Ultimate Guide: Replace Brakes on 2017 Hyundai Tucson
Every Hyundai vehicle, including the 2017 Tucson, comes equipped with a robust braking system designed to ensure your safety on the road. However, like any other component, brake pads wear out over time, necessitating replacement. Today, we'll walk you through a comprehensive guide on changing the brakes on a 2017 Hyundai Tucson.
Before you begin, ensure you have the right tools and materials, including a jack, a lug wrench, a torque wrench, new brake pads, a brake bleeder kit, and some high-quality brake fluid. Below are detailed step-by-step instructions, followed by exhaustive sub-topics to delve deeper into specific areas of the process.
Preparation and Removal of Existing Brake Components
Park your Tucson on a flat, stable surface and ensure the emergency brake is engaged. Begin by removing the lug nuts from the tire using the lug wrench. Lift the vehicle with the jack, support it securely with jack stands, and remove the tire completely.
Starting with the front brakes, locate the brake caliper and use a breaker bar and socket to loosen the caliper mounting bolts. Slide the caliper off the rotor and suspend it from the coil spring using a bungee cord to avoid straining the brake line. Next, remove the brake pads from the caliper bracket.
Inspecting the Brake System
With the brake pads removed, you can now inspect your brake system components. Check the rotor for any signs of warping or heavy rust buildup. Inspect the caliper piston andlider pins for functionality and cleanliness. Ensure that the anti-rattle clips are intact and performing their function.
If any components show signs of excessive wear or damage, they should be replaced along with the brake pads.
Preparing the New Brake Pads
Before installation, prepare the new brake pads. Most new pads come equipped with anti-squeal shims or metallic clips to prevent squealing when braking. Apply a thin layer of high-temperature grease at the rear of the pad to prevent squealing. Avoid applying grease to the friction material.
Installation and Bed-in Process
Begin by sliding the prepared brake pads into the caliper bracket. Ensure that the pad with the wear indicator features a visible exterior. Reposition the caliper over the pads and rotor. Align the caliper and bracket, then tighten the mounting bolts using a torque wrench. Tighten them to Hyundai's recommended specification of 27-34 ft-lb.
Repeat the process for the rear brake pads, which are virtually identical in design to the front. After installing the pads, use a brake bleeder kit to remove any air in the brake system, particularly in vehicles equipped with an Anti-lock Brake System (ABS).
olimping the Brake System
Remove the bleeder banjo bolt from the brake reservoir with a box-end wrench and reconnect the bleeder kit tubing. Priming the brake system involves forcing brake fluid through the lines and out of the bleeder valve. With the master cylinder covered, pump the brake pedal several times until firm, allowing the vehicle's hydraulic system to force fluid through the newly installed lines.
After bleeding the brakes, replace all tire lugs and torque them to Hyundai's specified requirement of 80-110 ft-lb. Lower the vehicle to the ground, release the emergency brake, and apply pressure to the brake pedal several times until firm. Finally, drive the car at low speeds to confirm brake pad contact with the rotors.
When replacing your 2017 Hyundai Tucson's brake pads, it is essential to remember that the bed-in procedure is as critical as the installation process. Drive cautiously for the first 100-200 miles to allow the brake pads to bed in, with particular emphasis on avoiding heavy braking.
Regular maintenance - including periodic checks of brake components and pad replacement as necessary - is the key to ensuring your Hyundai Tucson's braking system remains functional and reliable. Happy driving!