Easy Steps to Replace Your 2014 BMW Key Fob Battery
Is your 2014 BMW's key fob battery running low, or have you recently replaced it and now need to sync it to your vehicle? Replacing or reprogramming the battery in your key fob is a simple process that can save you the cost and inconvenience of a dealership visit. Let's walk you through the steps to change the battery on your 2014 BMW key fob.
First and foremost, safety should always come first when dealing with any electrical component. Ensure that your vehicle's ignition is off before proceeding and keep any metallic objects away from the key fob to prevent shorts.
Replacing the Battery
Before you start, gather a replacement battery (CR2032 or CR2025, depending on your key fob model), a small screwdriver, and a magnet.
Replacing the battery involves removing the old one and inserting the new one. Here's how to do it:
Removing the Old Battery
Look for the small slot on the side of your key fob. Use the edge of the screwdriver or a coin to pry it open. Slip the screwdriver or coin between the two case halves and twist gently to unlock them.
Remove the backing of the key fob. You'll see the battery stuck to the circuit board. Gently push the battery away from the circuit board using the edge of the screwdriver. It should slide off easily.
Inserting the New Battery
Before inserting the new battery, ensure the + and - sides match the locations on the circuit board. The + (positive) side faces up, and the - (negative) side faces down.
With the battery correctly oriented, press it firmly into the battery compartment. Ensure the entire battery surface makes contact with the circuit board. Replace the backing, pressing it firmly until you hear it click back into place.
Programming the New Battery
Once you've replaced the battery, you need to reprogram or sync it with your vehicle. This process varies slightly depending on your BMW model and whether you have a proximity key or a standard key fob.
For a proximity key, park your vehicle in a location where the hood doesn't interfere with the interior light. Turn off the ignition and ensure all doors, the trunk, and the liftgate are closed. Place the key fob on the driver's seat and ensure it's fully inserted into the ignition.
Programming with the Hood Open
Open the driver's door. Press and release the 'Lock' button on the remote control transmitter six times within 10 seconds. The turn signal lights should flash once after the sixth press. Now, close the driver's door, close the hood, and try to unlock the vehicle. If your key fob works, the programming is successful.
If the above method doesn't work, or your vehicle doesn't have a proximity key, you can try the traditional method. Park your vehicle with the ignition off. Take the key out of the ignition and place it on the driver's seat. Press and release the 'Lock' button on the remote control transmitter twice within two seconds. The turn signal lights should flash once when programmed successfully.