Step-by-Step: Change Oil on 2021 Toyota Rav4
Regular oil changes are crucial for keeping your 2021 Toyota RAV4 running smoothly and reliably. This article will guide you through the process of changing the oil on your Toyota RAV4 for optimal performance and longevity.
Before we begin, ensure you have all the necessary tools and materials. You'll need a 13mm socket wrench, an oil filter wrench, a 14mm socket wrench, an oil drain pan, a funnel, a torque wrench (if you have one), and around 6 quarts (5.7 liters) of 5W-30 or 0W-20 synthetic oil, as recommended by Toyota. Also, have 1 new oil filter ready.
Preparing Your Toyota RAV4 for the Oil Change
First, make sure your Toyota RAV4 is on a flat, stable surface to ensure safety and accuracy during the oil change.
Next, locate the oil pan and oil filter under your vehicle. The oil pan is directly beneath the engine, and the oil filter is usually found on the side of the engine, near the front. For your 2021 RAV4, these components are located in a safe and accessible manner for DIY oil changes.
Allowing the Oil to Warm Up
Performing an oil change when the oil is warm allows it to drain more effectively. Start your RAV4 and let it run for about 15-20 minutes to heat up the oil.
Once the oil is heated, turn off the engine and allow it to cool down for approximately 30 minutes. This will prevent any burns and make the oil change process more manageable.
Safely Lifting Your Vehicle
Use a jack to lift your 2021 Toyota RAV4 off the ground. Place jack stands under the vehicle's frame to securely support it. Ensure the vehicle is well-supported and stable before proceeding.
Before lifting your RAV4, consult your owner's manual to locate the correct and safe jack points. Never rely on the tires to support the vehicle's weight while changing the oil.
Draining the Oil and Replacing the Oil Filter
Now that your RAV4 is safely lifted, it's time to remove the old oil and oil filter.
Locate the oil pan drain plug at the bottom of the engine, near where the oil pan meets the engine block. It's a large, round plug with a 14mm socket.
Draining the Old Oil
Position your oil drain pan underneath the oil pan drain plug. Using your 14mm socket wrench, slowly loosen and remove the plug by turning it counterclockwise. Allow the old oil to drain completely into the pan. This process can take several minutes, so be patient.
Once the oil has stopped draining, wipe the area clean with a cloth to remove any residual oil. Inspect the drain plug and the area around the oil pan for any signs of damage or leaks.
Replacing the Oil Filter
Position a new oil filter (ensuring it's compatible with your Toyota RAV4) so that it's upright, with the arrow or oil fill hole facing up. This will help ensure proper oil flow once the filter is installed.
Gently lubricate the oil filter's rubber gasket with a small amount of new oil. This will help create a proper seal when the filter is installed. Remove the oil filter cap (if applicable) to allow easier access for the new filter.
Refilling the Engine with New Oil
Now that the old oil and oil filter have been removed, it's time to refill your RAV4's engine with new oil.
While the oil filter is still off, use a clean funnel to pour approximately 3.5 quarts (3.3 liters) of the recommended oil into the engine through the oil fill hole. Your owner's manual specifies the correct oil type and quantity for your 2021 RAV4.
Reinstalling the Oil Filter
Once you've poured the initial amount of oil, tighten the new oil filter by hand until it's snug. Then, give it a final 3/4 to 1 1/4 turns, or to the manufactuer's specified torque, usually around 25-30 ft-lbs (34-41 Nm). Use a torque wrench if you have one. Be careful not to overtighten the oil filter, as this can cause it to leak or become stuck during future oil changes.
Reinstall and tighten the oil pan drain plug by hand at first, then use a socket wrench to snug it. Again, be mindful not to overtighten; the drain plug should be tightened to a torque of approximately 25-30 ft-lbs (34-41 Nm).
Adding the Remaining Oil
After reinstalling the oil pan drain plug, let your RAV4 sit for a few minutes to allow the new oil to settle. Then, add the remaining oil (about 2.5 quarts (2.4 liters)) through the oil fill hole using a clean funnel.
Remove the oil fill cap and check the oil level using the dipstick. The ideal oil level should be within the 'FULL' range on the dipstick, but it may take a few minutes for the oil to settle completely. If necessary, add more oil in small increments until the level is within the 'FULL' range.
Resetting the Maintenance Required Light and Final Checks
Now that you've successfully changed the oil on your 2021 Toyota RAV4, it's essential to reset the 'MAINTENANCE REQUIRED' light. This light should have illuminated when you began the oil change process.
To reset the light, turn the ignition to the 'ON' position without starting the engine. Then, press and release the 'TRIP ODOMETER' button on your dashboard. The 'MAINTENANCE REQUIRED' light should now be off. If it doesn't go off immediately, it may take a few seconds or require multiple presses of the button.
Finally, check for any oil leaks around the oil pan and oil filter. Start your RAV4 and let it run for a minute, then inspect the area underneath the vehicle for any signs of leaks. If everything is in order, you're ready to safely lower your RAV4 off the jack stands and drive away, knowing you've successfully performed a vital maintenance task to keep your vehicle running smoothly.