Easily Replace Your BMW E90 Key Fob Battery: A Step-by-Step Guide
Ever found yourself locked out of your BMW E90 because your key fob's battery has died? Don't panic or shell out cash for a replacement. Replacing the battery in your BMW E90 key fob is a simple task that can be done at home. Here's a step-by-step guide to help you through the process.
Before you start, gather the following items: a small flathead screwdriver, a coin cell battery (CR2032), and a new key fob if you plan to replace both the battery and the fob at the same time.
Preparation and Tools
Make sure you have the right tools and parts for the job. A CR2032 battery is a 3-volt lithium coin cell, which is commonly used in key fobs, calculators, and other small electronic devices.
While you can use a specialized key fob opening tool, a small flathead screwdriver works just as well. Ensure the screwdriver's tip isn't too large to avoid damaging the fob's plastic.
Locate the Battery Compartment
The battery compartment on your BMW E90 key fob is hidden underneath the decorative plastic trim. This trim is typically held in place by a small latch that clicks into place when you snap the key fob together.
To locate the battery compartment, look for a small indent or notch on the edge of the key fob. This is where you'll insert your flathead screwdriver to pry the trim off.
Remove the Decorative Trim
Using your flathead screwdriver, gently insert it into the small indent on the edge of the key fob. Apply a little pressure and twist the screwdriver slightly to release the latch. The decorative trim should pop off easily.
If you feel any resistance, stop and try again. You don't want to snap the trim or damage the latch. Once the trim is off, set it aside carefully, as you'll need to reattach it once you're done.
Replace the Battery
With the decorative trim removed, you'll see a small compartment with the old battery inside. This compartment is held shut by a tiny metal clip. Be careful not to bend this clip while removing the old battery and installing the new one.
If you plan to replace the key fob as well, ensure that the new fob is compatible with your BMW E90 and its existing remote entry system. If you're unsure, consult your vehicle's owner's manual or contact a professional mechanic.
Remove the Old Battery
Use your flathead screwdriver to carefully lift the metal clip, allowing you to remove the old battery. The battery should slide out easily once the clip is released. If it sticks, gently twist the battery as you pull it out. Be cautious not to bend the contacts on the battery compartment.
Discard the old battery responsibly, following your local guidelines for electronic waste disposal. In many places, you can recycle coin cell batteries at facilities like Best Buy or through mail-in programs like Call2Recycle.
Install the New Battery
Grab your new CR2032 battery and alignment should be positive (+) side up. Match the positive side of the new battery to the positive contact in the compartment. Carefully insert the battery, pushing it in gently but firmly until it's fully seated. The metal clip should snap back into place, securing the new battery.
If the battery doesn't snap into place, double-check that you've inserted it correctly and try again. If the clip still doesn't engage, you might need to adjust the battery's position slightly.
Reassemble the Key Fob
With the new battery securely installed, it's time to put your key fob back together. Align the decorative trim with the edge of the key fob, and gently snap it back into place. You should hear the latch click as the trim pops onto the fob.
Test the key fob by pressing the lock and unlock buttons. If your BMW E90 doesn't respond, ensure that you've properly re-attached the decorative trim and that the new battery is fully inserted. If the key fob still doesn't work, you may need to reprogram it using your vehicle's remote entry system. Refer to your owner's manual for specific instructions.
Congratulations! You've successfully replaced the battery in your BMW E90 key fob. Regularly checking and replacing the battery whenever necessary will keep your key fob working at its best. Always remember to dispose of the old battery responsibly. Happy driving!